Road Sweeper Operating Procedures

One: cleaning work

1 Turn on the power to the control box and point the control valve to the secondary valve position

2 Start the slave

3 Point the auxiliary engine clutch control button to the closed position, the fan starts to work

4 Point the vacuum box control to the down position

5 Point the left or right swipe control to the down position

6 Point the swipe left or right swivel control to the forward position (clockwise for left disk, counter-clockwise for right disk)

7 Point the left water spray, right water spray, and rear water spray control buttons to the ON position

8 Point the pump control knob to the ON position

9 The vehicle travels at an appropriate speed and starts the cleaning action

Two: the end of cleaning

1 The vehicle stopped

2 Point the water pump control button, left water spray control button, right water spray control button, and rear water spray control button to the off position

3 Point the broom control to the middle

4 Point the swipe control to the up position, then to the middle position

5 Point the vacuum box control to up, then to the middle position

6 Point the auxiliary engine clutch control to the minute position and then to the neutral position

7 Point the control valve control key to the neutral position

8 Shut down the auxiliary engine

9 Power off the control box

Three: take out the garbage

1 Turn on the power of the control box and point the control knob of the control valve to the position of the main valve

2 Start the vehicle's main engine

3 Depress the vehicle clutch

4 Turn on the oil pump clutch switch attached to the vehicle (pull it out)

5 Disengage the vehicle clutch at the appropriate speed

6 Point the rear door control button on the control box to the open position, and then point to the middle position after 5 seconds

7 Point the control button of the carriage to the up position, according to the inclination angle of the carriage, you can point the control key to the middle position at any time, at this time the carriage is tilted up and stops.

8 Garbage cleaning

9 After the garbage is cleaned, point the control button of the carriage to the lower position, and point the control button to the middle position after the carriage is fully returned.

10 Point the back door control key to the closed position, and then point to the middle position after 10 seconds

11 Clean up junk ends

12 Depress the vehicle clutch

13 Close the additional oil pump clutch control (push in)

14 Release the vehicle clutch at the appropriate speed

15 Point the control valve of the control box to the neutral position

16 Power off the control box