Refuse transfer station transfer form

container compression

That is, various types of garbage collection vehicles arrive at the transfer station and dump the garbage into the garbage pit. There are push plates in the pit to push the garbage evenly into the garbage compressor, and then enter the garbage container through the compressor. After it is full, the garbage, special container and semi-trailer are pulled to the garbage disposal site by the tractor. The container semi-trailer itself is equipped with a hydraulic push plate device, and the tractor provides the power source to unload the garbage to the disposal site by itself.

Pre-compressed packing transfer method

The garbage is compacted and packed at the transfer station, bundled and stacked with wire, and finally transported to the disposal site by the transfer vehicle. This form of transfer station requires low moisture content of garbage and can only handle bagged garbage.

conveyor belt transfer

That is, after various types of garbage trucks enter the station, the garbage is unloaded on the bottom conveyor belt at the side of the pit, and the garbage is sent to the garbage transfer truck container by the conveyor belt, and finally transported to the disposal site. The biggest disadvantage of this form is It is high operating cost, high failure rate, and open storage of garbage, environmental pollution, mosquitoes and flies, and odor problems are more serious.

open topdirect loading

This form is to open the roof directly on the container, and the garbage collection vehicle directly discharges the material on the top. In some medium and small transfer stations, it is sometimes used. The main disadvantage is that the garbage is hardly compacted, the transportation efficiency is low, and several vehicles cannot be collected. The trucks are unloaded at the same time, and the loading process is not sealed, environmental pollution, mosquitoes and flies, and odor problems are more serious.

Grab direct-mounted transfer method

The collection truck dumps the garbage from the third floor to the second floor, pushes it by the bulldozer to the vicinity of the steering grab, and then grabs it from the steering grab and loads it into the container of the transfer truck. The biggest disadvantage of this form is that the space environment on the second floor is extremely harsh and the efficiency is low.

Shredded garbage transfer method

The garbage is sent to the transfer station, crushed by machinery, and then transported to the disposal site. Such a transfer station is expensive to invest, and the garbage disposal is slow. Except for special requirements, it is rarely used today.